Table of Contents
Advertisement
BLACK BAG
5
STEP
• If you are adding 15 weight plates to the
base unit, proceed as follows. If you are
adding 20 weight plates, the steel tube
spacer (5a) will not be used.
• Place two rubber weight plate bumpers
(5b) over the 0.75" holes of 5a. Place 5a
over the holes of 1b. With the horizontal
holes at the bottom, place the two guide
rods (5c) over and through the rubber
5f
weight plate bumpers and steel tube
spacers. Slide into the holes of 1b until they
rest at the bottom of 1b. Let the guide rods
tilt out to the right. Slide each of the 15
weight plates (5d) (or 20 if you purchased
the 5 additional plates) over both guide rods
on top of one another. The diagram shows
1a
the weight plates oriented to the left. This
may be beneficial if you are left handed.
2f
5c
You can orient them to the right, if so
desired. The pin can access the weight
plate holes from either side. Slide the
header weight plate (5e) over both guide
rods and down on top of the stack. Position
the pulley bracket of 5e like the photo to the
5e
left. Tighten the locking nut with a a 19mm
wrench.
• Mate the front of the top pulley structure
(5f) with the holes in 2f. The rear of 5f will
rest on the plate attached to 1a. Attach the
5b
front joint with two bolts (M10x1.5Px60L),
four flat (10.5x18x2T) and two nuts
5a
(M10x1.5P), using a 6mm L-shaped wrench
5d
and a 17mm wrench. Attach the rear joint
bolts (already welded on), with two
flat
(10.5x18x2T)
and
two
spring
(SW10.2x18.4x2.5T) washers, and two
nuts (M10x1.5P). Use a 17mm wrench and
a 6mm L-shaped wrench.
1b
5g
• Kneel down on the floor on the left side of
the weight stack. Place your right hand on
the rear guide rod (5b), above the weight
stack and lift the rod into the hole of 5f.
• Looking into the hole (5g), rotate the guide
rod until the hole lines up with the
hole in 1b. Insert a bolt (M6x1Px50L)
and a flat (6.4x14x1T) and spring
(SW6.1x12.2x1.5T) washer into the hole
and attach a nut (M6x1P) on the opposite
side. Repeat the process with the other
guide rod. Tighten the bolts with a 10mm
wrench and a 4mm L-shaped wrench.
13
Advertisement
Table of Contents
