Table of Contents
Advertisement
BLUE BAG
2
STEP
• Thread pull pins partially onto 2a (Qty. 1)
and 2c (Qty. 2).
• Lay the front center vertical (2f) on the
floor. Slide the seat support structure (2a)
over the open end of 2f. NOTE: You must
pull the pull pin out (2b) and hold it when
sliding over 2f. Release and engage the
pull pin in one of the lower holes of 2f.
• Slide the seatback support structure (2c)
over the open end of 2f. NOTE: You must
pull the pull pin (2d) out and hold, while
sliding over 2f. Release and engage the
2a
2c
pull pin in one of the upper holes of 2f.
2d
• Attach the exercise card post (2e) to the
2e
2b
appropriate holes of 2f with two spring
(SW6.1x12.2x1.5T) and flat (6.4x14x1T)
washers, and two bolts (M6x1Px15L).
Tighten the bolts using a 4mm L-shaped
wrench.
• Place 2f on top of 1b. Slip a flat
(10.5x18x2T) washer over each bolt
2f
(M10x1.5Px60L) and slide through the left
side. Attach a flat (10.5x18x2T) washer
and a nut (M10x1.5P) to each bolt on the
right side. Tighten using a 6mm L-shaped
wrench and a 17mm wrench.
1b
10
Advertisement
Table of Contents
