Samsung IER Series Installation Manual page 95

2-5. IER-F + IER-F L-Type Installation
Samsung Electronics
Cabinet Installation
• For IER-F L-type installation, use only two among four BOLT ETCs and remove the BOLT-ETCs not in use. (Fig. 21)
• In the joint where two cabinets are met (L-type corner), do not use the BOLT ETC but the outer BOLT-ETC. (Fig. 22)
• During L-type installation, a cabinet protrudes to cover another one. This direction can be determined, noting the L Support mark while installing the
Frame Kit. (Fig. 23
)
Fig 21. Removal of BOLT ETC Fig 22. Rear Panel during L-type Installation Fig 23. Overlapping Area of L-type Module
94