Table of Contents
Advertisement
SECTION 5
OPERATION CHECK
The initial operation check, which is performed after the unit is installed according to section 4 "INSTALLATION AND ASSEM-
BLING PROCEDURE", is mentioned in this section.
The operation check is performed by execute the auto test mode which is a part of test mode equipped BFC-1.
See maintenance manual section 5 "TEST MODE" about a method of operation.
When a trouble is occurred during executing the test mode, confirm the following.
It is able to look into the cause from the test mode that trouble occurred.
. Cause of the trouble is installation
. Cause of the trouble is a fault of the equipments
After finding cause of the trouble, take necessary steps according to the corresponding item in the installation manual or maintenance
manual.
5-1
BFC-1
Advertisement
Table of Contents
