Remodeling The Hand Assembly (For Dvcam) - Sony FLEXICART BFC-1 Installation Manual

4-12-3. Remodeling the Hand Assembly (for DVCAM)

It is necessary to remodel the hand portion so that the cassette for
DV can be retained.
Prepare BKFC-210 for the remodeling below.
1. Hand assembly removal
(1) Remove one screw, then remove the hand cover.
(2) Pull out the harnesses from connectors CN1 and CN2 on
the hand board.
Note: Pull out the harness from connector CN8
when a barcode reader (optional) is in-
stalled.
(3) Remove one screw, then remove the hand assembly
from the elevator.
2. Finger replacement
(1) Remove the three screws, then remove the finger (up-
per).
(2) Install the finger (DV) of BKFC-210 in the hand assem-
bly with three screws.
4-52
SCREW
(PWH 4x8)
SCREWS
(PWH 3x6)
SCREWS
(PWH 3x6)
FINGER (UPPER)
SCREW
(PWH 4x8)
HAND COVER
HAND ASSEMBLY
CN1
CN2
CN8
FINGER (DV)
BFC-1