Sony FLEXICART BFC-1 Installation Manual page 70

5. Replacement of BCR bracket
(1) Remove one screw, then remove the BCR bracket.
(2) Install the BCR bracket (DV) of BKFC-210 in the eleva-
tor with the screw (PWH 3x5) removed in step (1).
[Reference]
For the installation of a barcode reader, refer to Appendix
A in the Maintenance Manual.
[Note]
The remainder of the procedure vary with models.
.DSR-60/80 series
:See procedure 6 through 8.
.DSR-1600/1800/2000 series :See procedure 9 through 11.
6. Hand assembly installation
(For DSR-60/80 series VTRs)
(1) Install the hand assembly in the elevator with one screw.
(2) Connect the harnesses disconnected in step (2) of proce-
dure 1 to the former connectors.
7. Height confirmation of VTR shutter plate
(For DSR-60/80 series VTRs)
(1) Turn the gear shown in the figure so that the hand re-
tains the cassette while pressing the DV cassette against
the finger.
4-54
BRC BRACKET
SCREW
(PWH 4x8)
DV CASSETTE
SCREW
(PWH 3x5)
HAND
ASSEMBLY
CN1
CN2
CN8
GEAR
HAND
ASSEMBLY
BFC-1