Product Overview; Controls - Toro Groundsmaster 4500-D Operator's Manual

Product Overview

Controls

Figure 10
1. Brake pedal
2. Pedal-locking latch
3. Parking-brake pedal
Traction Pedal
The traction pedal (Figure
reverse operation. Press the top of the pedal to move
forward and the bottom to move backward. When the
cutting units are fully raised, the pedal controls the
engine and traction speed like a car.
Note:
In emergency braking situations, remove your
foot from the traction pedal and then press the brake
pedals. This is the quickest way to stop the machine.
Brake Pedals
There are 2 foot pedals that operate individual wheel
brakes for turning assistance, parking, and to aid in
better side-hill traction. A latch connects the pedals
for parking-brake operation and transport
Pedal-Locking Latch
The pedal-locking latch connects the pedals together
to engage the parking brake
Tilt-Steering Pedal
To tilt the steering wheel toward you, press the foot
pedal down, pull the steering tower toward you to
the most comfortable position, and release the pedal
(Figure 10). To move the steering wheel away from
you, press the foot pedal and release it when the
steering wheel reaches the desired operating position.
4. Traction pedal
5. Tilt-steering pedal
10) controls forward and
(Figure
(Figure 10).
Parking-Brake Pedal
To engage the parking brake,
pedals together with the pedal-locking latch and push
down on the right brake pedal while engaging the toe
pedal. To release the parking brake, press 1 of the
brake pedals until the parking brake latch retracts.
Key Switch
The key switch
O /P , and S
N REHEAT
g009979
1. Lift switches
(Groundsmaster 4700
machine only)
2. Lift switch (Groundsmaster
4500 and 4700 machines)
3. PTO switch
4. Key switch
PTO Switch
The PTO switch has 2 positions: O
( ). Pull the PTO button out to engage the
DISENGAGE
cutting-unit blades. Push the button in to disengage
the cutting-unit blades
10).
High and Low Speed Range Switch
This switch (Figure
ranges; high and low.
Select the H/L A
automatically select high or low speed.
Select the L
OW
speed only.
You can change the switch position at any time, but
the machine will only switch between speed ranges
when the traction pedal is in neutral and the machine
is stopped.
Note:
To get to high speed in the H/L A
disengage the PTO and fully raise the cutting units.
16
(Figure 10) connect the
(Figure 11) has 3 positions: O
.
TART
Figure 11
5. InfoCenter
6. High and low speed range
switch
7. Light switch
(
UT
(Figure 11).
11) controls the machines 2 speed
position to allow the machine to
UTO
position to manually override to low
,
FF
g296364
) and I
ENGAGE N
position,
UTO