Locating The Tie-Down Points - Toro Groundsmaster 4500-D Operator's Manual

2. Rotate each valve 3 turns counter-clockwise to
open and allow the fluid to bypass internally.
Note:
Do not open the valve more than 3
turns. Because fluid is bypassed, you can
move the machine slowly without damaging the
transmission.
Figure 74
1. Bypass valve (2)
3. Push or tow the machine.
4. Finish pushing or towing the machine and close
the bypass valve. Torque the valve to 70 N∙m
(52 ft-lb).
Important:
If you must push or tow the machine
in reverse, bypass the check valve in the 4-wheel
drive manifold.
To bypass the check valve, connect a hose
assembly to the reverse traction pressure test port
(located on the hydrostat) and on the port located
between ports M8 and P2 on the rear traction
manifold (located behind the front tire). The hose
assembly includes 1 hose (Part No. 95-8843), 2
coupler fittings (Part No. 95-0985), and 2 hydraulic
fittings (Part No. 340-77).
Locating the Tie-Down
Points
Note:
Use properly-rated DOT-approved straps in 4
corners to tie down the machine.
•
On each side of the frame by the operator's
platform
•
On the rear bumper
g036666
g225685
57
Figure 75
Figure 76
g208989
g036665