Adjusting The Roller Scraper - Toro Groundsmaster 4500-D Operator's Manual

Figure 6
1. Hood latch
8. Install the bolt into the other arm of the
hood-latch bracket to lock the latch in position
(Figure 7). Tighten the bolt but do not tighten
the nut.
Figure 7
1. Bolt
2. Nut
g012630
g012631
3. Arm of hood-latch bracket
3
Adjusting the Roller
Scraper
Optional
No Parts Required
Procedure
The optional rear roller scraper functions best when
there is an even gap of 0.5 to 1 mm (0.02 to 0.04 inch)
between the scraper and the roller.
1. Loosen the grease fitting and the mounting
screw (Figure
1. Roller scraper
2. Mounting screw
2. Slide the scraper up or down until you obtain a
gap of 0.5 to 1 mm (0.02 to 0.04 inch) between
the rod and the roller.
3. Tighten the grease fitting and screw to 41 N∙m
(30 ft-lb) in an alternating sequence.
14
8).
Figure 8
3. Grease fitting
g011346