Toro Groundsmaster 4500-D Operator's Manual page 32

Viewing and Changing the
Protected Menu Settings
1. In the Protected Menu, scroll down to Protect
Settings.
2. To view and change the settings without entering
a PIN code, use the right button to change the
Protect Settings to O
3. To view and change the settings with a PIN
code, use the left button to select O
PIN code, and turn the key to the O
and then to the O
Setting the Maximum Allowed
Mow Speed
The selected setting is displayed as an X on the
traction-speed bar graph along with the cruise control
and pedal stop settings. An X in a bar shows you
that the maximum speed is limited by the supervisor
(Figure 29 or Figure 31).
Note:
This setting is retained in memory and applied
to the traction speed until you change it.
1. In the Settings Menu, scroll down to Mow Speed
and press the right button.
2. Use the right button to increase the maximum
mow speed in 5% increments between 50% and
100%.
3. Use the center button to decrease the maximum
mow speed in 5% increments between 50% and
100%.
4. Press the left button to exit.
Setting the Maximum Allowed
Transport Speed
The selected setting is displayed as an X on the
traction-speed bar graph along with the cruise control
and pedal stop settings. An X in a bar shows you
that the maximum speed is limited by the supervisor
(Figure 29 or Figure 31).
Note:
This setting is retained in memory and applied
to the traction speed until you change it.
1. In the Settings Menu, scroll down to Transport
Speed and press the right button.
2. Use the right button to increase the maximum
transport speed in 5% increments between 50%
and 100%.
3. Use the center button to decrease the maximum
transport speed in 5% increments between 50%
and 100%.
.
FF
, set the
N
position
FF
position.
N
4. Press the left button to exit.
Turning the Smart Power ON/OFF
1. In the settings menu, scroll down to Smart
Power.
2. Press the right button to switch between O
O .
FF
3. Press the left button to exit.
Setting the Counterbalance
1. In the Settings Menu, scroll down to
Counterbalance.
2. Press the right button to select counterbalance
and change between the L
H settings.
IGH
Actuating Turnaround ON/OFF
1. In the Settings Menu, scroll down to Turnaround.
2. Press the right button to switch between O
O .
FF
3. Press the left button to exit.
Setting the Acceleration Mode
1. In the Settings Menu, scroll down to Acceleration.
2. Press the right button to switch between L
M , and H
EDIUM
3. Press the left button to exit.
Viewing the Fuel Consumption
Rate
You can view the average fuel consumption rate for
the lifetime of the machine in the Service Menu.
Setting the Service Due Timer
This resets the service due hours after a scheduled
maintenance item is preformed.
1. In the Service Menu, navigate to the Hours
Menu.
2. Scroll down to the Reset Service Due option and
press the right button.
3. Press the left button to exit.
32
, M
OW EDIUM
.
IGH
and
N
, and
and
N
,
OW