Figure 57
Accounting Server tab
Install and configure IP Trunk 3.01 (and later) node
Procedure 23
Configuring a Radius Accounting Server
1
Click the Accounting Server tab. See Figure 57.
2
Click the Enable Radius accounting records checkbox.
3
Enter the Radius accounting server IP address. Add the same Accounting
Server IP address that was configured in the Card Routing Table entries
as discussed in "Configure SNMP Traps/Routing and IP addresses tab"
on
page
329.
4
Change the default port number from the default (1813), if required.
5
Enter the key. The key is a signature for authentication of the Radius
records. It can be a maximum of 64 alpha-numeric characters.
IP Trunk
Description, Installation, and Operation
Page 333 of 644