Nortel 1000 Description, Installation And Operation Manual page 301

LD 14 – Configure Media Card 32-port and ITG-Pentium 24-port trunk cards and
units (Part 2 of 5)
Prompt
TN
DES
XTRK
MAXU
Install and configure IP Trunk 3.01 (and later) node
Response
l s c u
c u
hhhh:hh:hh:hh:hh
xxx.xxx.xxx.xxx
MC32
MC24
xx
Description
Terminal number
Format for Large System, Call Server 1000E, and
Media Gateway 1000E, where l = loop, s = shelf,
c = card, u = unit
Format for Small System, CS 1000S system,
Media Gateway 1000B, and
Media Gateway 1000T, where c = card
and u = unit
16 character descriptive designator for the IP trunk
card.
See Note 1.
For unit 0. The IP trunk card management MAC
address.
For units 1 – 23. The IP trunk card management IP
address.
Extended Trunk Type: IP trunk card (1-slot or
2-slot assembly).
Single slot, 32-port StrongArm (SA) processor
Media Card.
Double slot, 24-port Pentium processor Media
Card.
Maximum number of ports on this IP trunk card,
where:
xx = 32 for the Media Card 32-port trunk card
xx = 24 for the ITG-Pentium 24-port trunk card
Note: A warning message is printed if a number
larger than 24 is entered for MAXU. Ignore this
warning for the Media Card 32-port trunk card.
IP Trunk Description, Installation, and Operation
Page 301 of 644