Nortel 1000 Description, Installation And Operation Manual page 272

Page 272 of 644
553-3001-363 Standard 2.00
Install and configure IP Trunk 3.01 (and later) node
Procedure 13
Installing cables on Small Systems
1 Set the switches and jumper plugs in the NTAK02 SDI/DCH card as
shown. See Table 46 and Table 47.
Table 46
NTAK02 SDI/DCH switch settings for IP Trunk 3.01 (and later) DCHIP
Port 1
DCH
Port 3
DCH
Table 47
NTAK02 SDI/DCH jumper settings for the IP Trunk 3.01 (and later)
DCHIP
Jumper
Port location
Port 1
Port 3
2 Connect the NTAK19FB Quad Serial I/O SDI/DCH Cable (or equivalent)
to the I/O connector for the card slot in which the SDI/DCH card is
installed.
3 If the DCHIP card is installed in the main cabinet with the SDI/DCH card,
then use NTWE04AD SDI/DCH Extension Cable (1 ft) from the
NTCW84KA DCH (P5) connector to the NTAK19FB D-Channel port
connector for Port 1 or Port 3.
September 2004
SW 1-1
OFF
SW 1-3
OFF
Strap for
DTE
J7 C – B
J6 C – B
J4 C – B
J3 C – B
SW 1-2
OFF
SW 1-4
OFF
Jumper
location RS422
J9 C – B
J8 C – B
J2 C – B
J1 C – B