Cisco Unified IP Phone 8941 Administration Manual page 116

Telephony Features
Feature
Programmable Feature Buttons
Programmable Feature Buttons as
Softkeys
Quality Reporting Tool (QRT)
Redial
Reroute Direct Calls to Remote
Destination to Enterprise Number
Remote Port Configuration
Remotely Check CTL and ITL File
Cisco Unified IP Phone 8941 and 8945 Administration Guide for Cisco Unified Communications Manager 10.0
(SCCP and SIP)
102
Description
Enables you to assign features, such as New Call, Call Back, and Forward All, to line buttons.
See:
• Phone Button Templates, on page 115
• Cisco Unified Communications Manager System Guide, "Cisco Unified IP Phone"
• Cisco Unified Communications Manager Administration Guide, "Phone Button Template
Configuration"
Enables you to configure features on buttons or softkeys.
See Set Up Softkey Template, on page
Allows users to submit information about problem phone calls by pressing a button. QRT can
be configured for either of two user modes, depending upon the amount of user interaction
desired with QRT.
See:
• Cisco Unified Communications Manager System Guide, "Cisco Unified IP Phone"
• Cisco Unified Communications Manager Features and Services Guide, "Quality Report
Tool"
Allows users to call the most recently dialed phone number by pressing a button or Redial.
No configuration required.
Reroutes a direct call to a user's mobile phone to the enterprise number (desk phone). For an
incoming call to remote destination (mobile phone), only the remote destination rings; the
desk phone does not ring. When the call is answered on the mobile phone, the desk phone
displays a Remote In Use message. During these calls, users can make use of various
features of their mobile phone.
See the Cisco Unified Communications Manager Features and Services Guide, "Cisco Unified
Mobility" chapter.
Allows you to configure the speed and duplex function of the phone Ethernet ports remotely
by using Cisco Unified Communications Manager Administration. This enhances the
performance for large deployments with specific port settings.
Note If the ports are configured for Remote Port Configuration in Cisco Unified
Communications Manager; the data cannot be changed on the phone.
See Set Up Remote Port Configuration, on page
Enables the user to view the CTL and ITL signatures and information about the server from
which the signatures were downloaded.
See Cisco Unified Communications Manager Administration Guide.
117.
127.