Singer 2700 Series Service Manual page 59

Service Manual
Removal:
1. Remove the free-arm extension table, all the covers, the needle plate, the feed dog,
the feed lifting lever assembly (N), the hook pulley (K) and the belt (M).
2. Remove the 10 mm nut (H) and eccentric hinge screw ( I ).
3. Remove feed rock shaft center screws (F) and (L).
4. Remove feed rock shaft assembly (J) together with shaft centers (B) and (E) and with
washers (C) and (D).
Replacement:
1. Replace feed rock shaft assembly (J), shaft centers (B) and (E) together with washer
(C) and (D).
2. Tighten shaft centers screws (F) and (L).
3. Replace feed lifting lever assembly (N) and then replace the feed dog (see pages
120-121).
4. Replace eccentric hinge screw ( I ) and hinge screw nut (H). Tighten nut (H) to finger
tightness.
5. Adjust feed dog centralization and feed rock shaft end play. (See pages 122-123).
6. Adjust feed dog height.(See pages 122-123).
7. Adjust feed dog throw.(See pages 124-125).
8. Replace the pulley (K) and the belt (M). (See also pages
9. Adjust the hook timing (See pages 110-111).
Rev. n .
o
AGO/03
Feed Rock Shaft Assembly
58
51-52) .
359109-000 AGO/03