Table of Contents
Advertisement
Service Manual
Removal:
1. Set feed regulator dial at number "5" (maximum stitch lenght).
2. Turn handwheel toward the front of the machine to bring the feed dog to its furthest
rear position.
3. Remove the free-arm extension plate and all the covers.
4. Remove screws (G) to clear the eccentric pin (F) from clamp (D).
5. Remove the spacer (A), the spring (B) and the feed lifting lever assembly (C).
Replacement:
1. Replace these parts the same way as described above, but in a reverse order.
2. Position the eccentric stud (F) making sure spacer (A) is positioned with the hole
offset against the feed lifting lever bushing.
3. Adjust feed dog height related to needle plate surface (see pages 122-123).
4. Be sure spring (B) is properly located in the hole of the casting and inserted over the
nib in the feed lifting lever (C).
Rev. n .
o
AGO/03
Feed Lifting Lever Assembly
(For models 2712 / 2718)
56
359109-000 AGO/03
Hide quick links:
Advertisement
Table of Contents
