Back Panel Replacement; Line Terminator Replacement - Fujitsu M2361A Customer Engineering Manual

6.6.13 Back panel replacement
(1) Removal
CD
Remove all the PCBs in the card cage.
CD
Remove the connectors (CN11, 12, 15
~
17) and SG wire on the back
panel PCB (BRAMU).
0)
Remove the interface PCBs. (Refer to subsection 6.6.7.)
@ Remove the 4 screws "A" fixing the card cage for interface PCBs.
~
Remove the 2 screws "B" holding the back panel PCB.
(§)
Remove the 4 screws " C" fixing the card cage and the PCB to the base
plate of the drive.
CD
Pull up the back panel assembly from the drive base.
®
Remove the 8 screws "0" fixing the PCB to the card cage, and pull
apart the PCB.
(2) Installation
Follow, in reverse order, the procedures for removal.
6.6.14 Line terminator replacement
Refer to Figure 2.6.1.
(1) Removal
CD
Remove the screw holding the GND cable of the line terminator PCB to
the GND terminal on a interface PCB.
CD
Pull and remove the line terminator PCB.
(2) Installation
Follow, in reverse order, the procedures for removal.
Caution: The line terminator PCB must be inserted with care to the "Out"
connector for the A-cable.
6 - 20 B03P-482S-0002A ••• 01