Figure 2.7.6 Cable Mounting (Rear View) - Fujitsu M2361A Customer Engineering Manual

h. Cable Mounting (See Figure 2.7.6)
CD
Remove the 2 screws
(A)
holding the cable clamp (1).
GD
Remove the 2 screws (B) holding the cable clamp (2).
CD
Connect A-cables to the upper connectors on the interface PCB.
®
®
The IN A-cable must be connected to the right connector and the
OUT A-cable must be connected to the left connector on each
interface PCB.
Connect B-cable to the lower connector on the interface PCB.
Clamp A-cable using the clamp (2) for A-cable and the 2 screws
(B).
Clamp B-cable using the clamp (1) for B-cable and the 2 screws
(A) •
Connect the GND lines of the interface cables to FG using the
screws (C).
If necessary, install the line terminator PCB in the "out"
connector for A-cable of the interface PCB. Connect the GND
cable of the line terminator PCB to the GND terminal on the
interface PCB using the screw (D).
Interface PCB - - - -
(Basic)
Screw (C)
GND Cable
A<able's connector
(OUT)
A-Cable
GND Cable
Clamp
(2)
Screw (D)
GND Cable
Line Terminator PCB
Interface PCB
(Dual port)
A-cable's connector
(IN)
B~ble's
connector
Screw (A)
Clamp
(1)
Figure 2.7.6 Cable mounting (Rear view)
B03P-4825-0002A ••• 02
2 - 15