Remote Access With The Handset - Uniden DCT5280 Owner's Manual

[ 62 ] T H E I N T E G R A T E D A N S W E R I N G D E V I C E
Command Function
0 1
then Repeat a Message*
0 2
then Playing incoming Messages
0 3
then Skipping a Message
0 4
then Deleting a Message
0 5
then Stop Operation
* For Repeat a Message function, press 0 then 1 within about four seconds to repeat
the previous message, or press 0 then 1 after about four seconds to repeat the
current message.
** For Memo Record and Greeting Message Record function, the first time you enter the
corresponding command, it starts the Recording function. If you want to stop the
recording, press 0 then 7 or 8.
5) After the command has finished, you hear intermittent beeps indicating that the
system is in the command waiting mode. You may enter another command at this
time from the chart above.
6) When you are finished, hang up to exit the system. The answering system
automatically returns to standby.

Remote access with the handset

You can check your new incoming messages, skip, repeat, or delete your incoming
messages with the handset. For example, you can install the answering system in the
living room, and check your incoming message from a bedroom with the handset.
You can also use speakerphone on the handset for remote operation (see "Making and
receiving calls" on page 31).
• If you press the end key before the answering system answers, the phone will return to standby.
• When the answering system does not answer within 6 seconds, you hear a beep and the
phone will return to standby.
• The base's keypad is disabled during remote operation.
• When you receive a call, the remote operation is canceled.
• You can change the handset volume during a remote operation.
• During the remote operation "
Command Function
0 6
then Answering System On
0 7
then Memo Record/Stop **
0 8
then Greeting Message Record/Stop **
0 9
then Answer System Off
1 0
then Help Guidance
" appears on the base.