Table of Contents
Advertisement
BEFORE USE
ASSEMBLING THE STAND
Assemble the stand as shown. The upper and lower beams are secured with
the 12 x M8 coachbolts with flat washers & nuts. Add the rubber feet securing
them with flat washers & nuts.
Do not tighten the nuts until all bolts are in place and the stand is rocked to
ensure it is stable and evenly assembled. When satisfied, tighten securely.
WITH ASSISTANCE, considering its weight, place the sander on top of the stand.
Position it so that the bolt holes, viewed from below, line up. Enter the 13mm
bolts fitted with flat and lock washers and tighten securely from below.
FITTING THE DRIVE COMPONENTS
1. Fit the drive housing to the frame
using 4 x M8 x12 retaining bolts
and flat washers.
Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com
9
Advertisement
Table of Contents
