Table of Contents
Advertisement
2. Slide the 5 x 55 mm parallel key
into the groove in the shaft and
slide driven pulley onto the end of
the driven shaft, engaging with
the key.
3. Pass the drive belt over both
pulleys and slide the motor pulley
onto the motor shaft complete
with the 5 x 25 mm parallel key.
4. Press both pulleys onto the shafts
as far as they will go. This will ensure that they are correctly aligned.
5. Using the hex wrench supplied,
tighten the M8 x 10 setscrews to
secure the both pulleys.
6. Tension the drive belt as necessary
by adjusting the position of the
motor on the bedplate using the 4
adjusting bolts.
• As a rough guide, aim for
approx 12mm deflection at the
mid-point of the drive belt and
confirm there is no slippage of
the belt on the pulleys.
7. Slide the face plate onto the
driven shaft, engaging with the
parallel key already in postion.
8. Use the hex wrench supplied to
tighten the setscrew and secure
the face plate to the driven shaft,
inserting the wrench through the
access slot in the drive cover.
Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com
10
Advertisement
Table of Contents
