Sanding Disc Table; Adjustments Before Use; Disc Table Adjustment - Clarke Woodworker CBS1-5B Operation & Maintenance Instructions Manual

SANDING DISC TABLE

1. Line up the table pins with the L
shape slots on either side of the
sanding disc, push the table in as
far as possible.
2. Screw the locking handwheels
through the machined slots into
the pre-drilled hole until finger
tight.

ADJUSTMENTS BEFORE USE

DISC TABLE ADJUSTMENT

1. Put an engineers square on the
table and slacken the locking
handwheels slightly.
2. Adjust the table so it is at right
angles to the disc then tighten the
locking handwheels.
3. If a different angle is necessary
use an angle setting guage to
guarentee precision.
Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com
7