Table of Contents
Advertisement
BEFORE USE
FITTING/REMOVING THE SANDING PAD
1. Rotate the eccentric wheel by
hand until the locking hole can be
seen through the slot in the front
housing.
2. Insert the drive locking tool into the
hole to stop the drive from
rotating.
3. Hold the drive locking tool firmly
while screwing on the sanding pad
clockwise. Make sure the sanding
pad is tight and secure.
4. The pad can be removed by unscrewing anticlockwise.
FITTING/REMOVING THE SANDING DISC
1. Fit the backing disc to the sander
by locking the moving drive
spindle with the key supplied and
screwing the disc tightly into
place.
2. Select the disc to be used which
MUST be correct disc with hook
and loop backing.
3. Press the disc firmly onto the pad
to secure it.
CONNECTING THE AIR SUPPLY
WARNING: COMPRESSED AIR CAN BE DANGEROUS. ENSURE THAT YOU
ARE FAMILIAR WITH ALL PRECAUTIONS RELATING TO THE USE OF AIR
COMPRESSORS AND A COMPRESSED AIR SUPPLY.
1. Connect one end of the hose to the compressed air supply.
2. Remove the protective plug from the air inlet and connect a suitable hose
as shown.
Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com
7
Advertisement
Table of Contents
