Table of Contents
Advertisement
8
Installation
4 Loosely install the 4 or 5 T-10 Torx screws that came with the fan assembly into the LTM
Used for 5-in.
module
Figure 45.
5 Place the fan assembly bracket over the mounting screws, then tighten the screws until
6 Route the fan cable through the slot and gap in the lower left of this bracket where it
7 Connect the fan cable to the electronics board at P6 (or P9 for module 2). See
90
oven door. See
Figure
45.
Slot
Fan bracket mounting screw locations
snug.
attaches to the door.
Slot
Figure
42.
User Guide
Advertisement
Table of Contents
