3
Column Modules
End of arm
Maximum
extension
Lightly tighten
8 If a union hanger is already installed, slightly loosen the mounting screw so that the hanger
9 Slide the column end through a CFT union and place the CFT union into the hanger as
Do not overtighten the internal nut into the fitting! A properly swaged and tightened CFT
C AU T I O N
connection will remain leak free for many connections.
40
can slide when needed.
shown.
•
For new installations, again check that the hanger is at maximum extension without
extending past the end of the arm as shown below.
•
For existing installations, slide the hanger to reach the open column end.
Hanger body
does not
extend past end
of arm
User Guide