Table of Contents
Advertisement
3
Column Modules
All electrical cable connectors for any one module (column and transfer line) must connect
C AU T I O N
to the same section on a single electronics board. See
11 Connect the column cable and transfer line cables to the electronics board.
48
•
The connectors are keyed and will only go onto the board one way.
•
If removing transfer line connectors from the board, remove them by gripping the
connector and not by pulling on the cable. The cable wires are easily damaged.
•
The transfer line cables can go to either transfer line connector on the electronics board
(as long as it is for the correct module).
•
Check your work. Make sure each connector installed over all pins, not just one row.
See
Figure
32,
Figure
33,
Figure
34, and
Table
5.
Figure 32
and
Figure
33.
User Guide
Advertisement
Table of Contents
