Transfer/Separation Corona Wire Replacement - Ricoh Robin Service Manual

AROUND THE DRUM
6.6 TRANSFER/SEPARATION CORONA WIRE
REPLACEMENT
[C]
[B]
1. Open the front cover.
2. Open the upper unit by pushing the release lever.
3. Pull the transfer/separation (TC/SC) corona unit [A] toward the
registration roller side (1) and release the left positioning tabs [B] of the
TC/SC unit from the left holders [C] in the transport unit (2). Then, take
out the TC/SC unit (3) as shown.
4. Remove the following parts:
•
TC/SC unit front endblock cover [D]
•
TC/SC unit rear endblock cover [E]
•
TC/SC unit paper guide [F]
NOTE: When reinstalling the TC/SC unit paper guide, verify that all three
tabs [G] are properly latched in place.
5. Unhook the springs [H] from the wires.
[A]
[G]
[H]
5-48
24 June 1994
[E]
[F]
[D]