Ricoh Robin Service Manual page 216

24 June 1994
9.3.2 Drum Anti-condensation Heater Installation
[C]
[B]
1. Open the front cover.
2. Open the upper unit by pushing the release lever.
3. Pull the transfer/separation (TC/SC) corona unit [A] toward the
registration roller side (1) and release the left positioning tabs [B] of the
TC/SC corona unit from the holders [C] of the transport unit (2). Then take
out the TC/SC corona unit (3).
4. Remove the harness cover [D] (2 screws).
5. Install the anti-condensation heater [E] (2 screws) and connect the heater
connector [F].
[A]
[D]
[F]
5-91
OTHERS
[E]