Huawei UA5000 Commissioning Manual page 21

UA5000 Universal Access Unit Product
Commissioning Guide-PVM CLI
DIP switch S7 is used to set the reporting mode and ratio.
settings of S7.
Table 3-4 Meanings and settings of the H303ESC S7
DIP Switch
S7-1
S7-2
S7-3
S7-4
Jumpers and DIP Switches of H304ESC
The H304ESC board provides two DIP switches, S2 and S3, and five jumpers S4-S8. The S9 is
the shielding switch for the alarm buzzer of the board, which is enabled by default.
3-2
Figure 3-2 Layout of the jumpers and DIP switches on the H304ESC board
Jumpers S4-S8 are used to set the serial port type.
of S4-S8.
Issue 04 (2012-06-25)
Settings
ON
OFF
ON
OFF
Reserved
ON
OFF
shows the layout of the jumpers and DIP switches on the H304ESC board.
O F F S 2
S 4
S 5
S 6
S 7
S 8
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Meanings
The H303ESC board is used in the
access network.
The H303ESC board is used in the
Local Exchange.
The H303ESC board uses one serial
port for reporting.
The H303ESC board uses two serial
ports for reporting.
-
The reporting ratio of the serial port
is 19200 bit/s.
The reporting ratio of the serial port
is 9600 bit/s.
O N
1 2 3
Table 3-5
3 Stand-Alone Commissioning
Table 3-4 provides the meanings and
Default
Settings
ON
ON
ON
ON
H3 0 4 E S C
S 9
O N S 3 O F F
provides the meanings and settings
Figure
D 6
13