Changing The System Name; Configuring A System User; Adding A System User - Huawei UA5000 Commissioning Manual

UA5000 Universal Access Unit Product
Commissioning Guide-PVM CLI
----End
Result
Run the display fe command to check the working status of the uplink port. The system displays
the communication mode of the port.

3.13 Changing the System Name

This topic describes how to customize the useful system name to differentiate UA5000s. This
facilitates the management of the UA5000.
Context
l
l
l
Procedure
Step 1 Run the sysname command to change the system name.
----End
Result
The CLI prompt character changes to the system name that is set after the command is executed
successfully.

3.14 Configuring a System User

When accessing, configuring, and managing the UA5000, you need to add the system operation
users with different attributes. This topic describes how to add system operation users and modify
the attributes of the system operation users.

3.14.1 Adding a System User

When accessing and configuring the UA5000, you need to add the system users with different
attributes to facilitate management.
Prerequisites
You must have the administrator right or higher right.
Issue 04 (2012-06-25)
– If the control board is PVMD, and the upstream IPMB board is in slot 3, run the
display fe active inner_FE1 command to check whether the internal communication
port (inner_FE1 port) between PVMD and IPMB is in the normal state.
By default, the system name is UA5000.
The system name takes effect immediately after it is changed.
After the system name is changed, the CLI prompt character changes to the new name
accordingly.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
3 Stand-Alone Commissioning
79