INSP
ADJ
LOWER UNIT/GENERAL
3240
3250
CHECKING THE LOWER UNIT
(FOR AIR LEAKS)
Check:
• Lower unit holding pressure
Pressure drops → Check the seals and
components.
Lower unit holding pressure
100 kPa (1.0 kg/cm
Checking steps
CAUTION:
Do not overpressurize the lower unit.
Excessive pressure may damage the oil
seals.
(1) Remove the gear oil level check screw.
(2) Install the pressure tester into the
check hole.
Pressure tester
YB-35956 / 90890-06762
(3) Apply the specified pressure.
NOTE:
The lower unit should hold the specified
pressure for 10 seconds.
GENERAL
CHECKING THE ANODES
Check:
• Anodes 1
• Trim tab 2
Scales → Clean.
Grease/oil → Clean.
Excessive wear → Replace.
CAUTION:
Do not oil, grease or paint the anode, or it
will not operate properly.
3-18
E
3
2
, 14.2 psi)
3
3