Changing And Checking The Gear Oil - Yamaha Z200N Service Manual

INSP
ADJ
LOWER UNIT
3220
3230
CHANGING AND CHECKING THE
GEAR OIL
1. Check:
• Gear oil
Milky oil → Replace the oil seal.
Slag oil → Check the gears, bearings,
and clutch dog.
Checking steps
(1) Tilt up the outboard slightly.
(2) Place a container under the gear oil
drain screw 1.
(3) Remove the gear oil drain screw and
gear oil level check screw 2.
2. Fill:
• Gear oil
(with the specified amount of the rec-
ommend gear oil)
Recommended gear oil
GEAR CASE LUBE (USA) or
Hypoid gear oil, SAE 90
Total amount
Regular rotation models
980 cm
(33.1 US oz, 34.5 Imp oz)
Counter rotation models
870 cm
(29.4 US oz, 30.6 Imp oz)
Filling steps
(1) Place the outboard in an upright posi-
tion.
(2) Insert the gear oil tube into the drain
hole and slowly fill the gear oil until oil
flows out of the check hole and no air
bubbles are visible.
(3) Install the gear oil level check screw
and then quickly install the gear oil
drain screw.
Gear oil level check screw
7 Nm (0.7 m • kgf, 5.1 ft • lb)
Gear oil drain screw
7 Nm (0.7 m • kgf, 5.1 ft • lb)
3-17
3
3
E
3