INSP
ADJ
POWER TRIM AND TILT SYSTEM
3195
3200
3210
POWER TRIM AND TILT SYSTEM
CHECKING THE POWER TRIM AND
TILT FLUID LEVEL
Check:
• Power trim and tilt fluid level
Level is low → Add power trim and tilt
fluid to the proper level.
Recommended power trim and
tilt fluid
ATF Dexron II
WARNING
When removing the power trim and tilt res-
ervoir cap, the power trim and tilt fluid may
spurt out due to internal pressure. Highly
pressurized fluid could sproy out causing
serious injury. Therefore, fully tilt up the
outboard (the tilt ram assembly fully
extended) and then slowly remove the
power trim and tilt reservoir cap.
Checking steps
(1) Tilt the outboard all the way up and
lock it with the tilt stop levers 1.
WARNING
After tilting up the outboard, be sure to
support it with the tilt stop levers.
Otherwise, the outboard could suddenly
lower if the power trim and tilt unit should
lose fluid pressure.
(2) Remove the reservoir cap 2 and check
the fluid level.
NOTE:
The fluid level should be directly below the
check hole as shown.
(3) Add power trim and tilt fluid if needed,
and then install the reservoir cap.
Reservoir cap
8 Nm (0.8 m • kgf, 5.8 ft • lb)
3-15
E
3
3