INSP
ADJ
a
4
7
5
3130
CONTROL SYSTEM
6
1
2
3
8.0 mm (0.31 in)
3135
2. Adjust:
• Remote control throttle cable length
Adjustment steps
(1) Loosen the locknut 1 and stopper
screw 2.
(2) Loosen the locknut 3.
(3) Remove the clip 4.
(4) Disconnect the throttle cable joint 5.
(5) Set the remote control lever to the
fully closed position.
(6) Align the center of the throttle control
lever cam roller 6 with the mark a.
(7) Tighten the stopper screw 2 until it
contacts the throttle control lever 7.
(8) Tighten the locknut 1.
(9) Adjust the position of the throttle cable
joint until its hole aligns with the set
pin on the throttle control lever 7.
(10) Install the clip 4 and tighten the lock-
nut 3.
CAUTION:
The remote control cable joint must be
screwed in more than 8 mm (0.31 in).
CHECKING THE DRIVE BELT
Check:
• Drive belt
Wear/damage → Replace.
Refer to "DRIVE BELT" on page 4-22.
3-11
E
3