Mount The Airbridge To A Pole - NETGEAR AirBridge WBC502 Hardware Installation Manual

Insight Instant AirBridge WBC502 Hardware Installation Guide
To mount the AirBridge to a wall:
1. Using screw placement guide, mark the location for the holes on the wall where you
want to mount the AirBridge.
The holes must be 2.13 in. (54 mm) apart, center to center.
2. Drill holes into the wall for the two anchors in which you will insert the M3 x L16 mm
screws.
The screws and anchors are in a plastic bag in the package.
0
1
2
3
4
5
3. Insert the anchors into the wall and tighten the screws with a No. 2 Phillips screwdriver.
Leave about ¼ inch (6 mm) of each screw protruding from the wall so that you can
insert the screws into the holes on the back panel of the AirBridge.
4. Line up the holes on the back panel of the AirBridge with the screws in the wall and
mount the AirBridge to the wall.

Mount the AirBridge to a pole

The back panel of the AirBridge provides an opening for the strap for pole mounting.
The AirBridge package includes a pole-mounting strap.
To mount the AirBridge to a pole:
1. Using a screwdriver, open the supplied pole-mounting strap.
Installation
0
1
2
3
4
5
41 Hardware Installation Guide