Step 4: Set Up The Wifi Connection Between A Master And A Satellite; Step 4A: Set Up The Wifi Connection On The Master At The Main Site - NETGEAR AirBridge WBC502 Hardware Installation Manual

Insight Instant AirBridge WBC502 Hardware Installation Guide
• Installation guide
• Wall mounting screws (2), anchors (2), and paper screw placement guide (not
shown in the previous figure)
5. If any item is missing or damaged, contact your local NETGEAR reseller for
replacement.
Step 4: Set up the WiFi connection between
a master and a satellite
This step refers to a configuration with two AirBridges that function in a master-to-satellite
setup.
We recommend that you complete the initial pairing of the AirBridges at a staging area
with easy access to the network that is to supply connectivity to the master.
This hardware installation manual describes the hardware setup, not the software
configuration, which you must perform using one of the following management methods:
• Local browser UI. See the user manual, which you can download from
netgear.com/support/download/.
• NETGEAR Insight. Visit netgear.com/insight and see the NETGEAR knowledge base
articles at netgear.com/support.
Perform the setup of the WiFi connection in the following order:

• Step 4a: Set up the WiFi connection on the master at the main site

• Step 4b: Set up and establish the WiFi connection on the satellite at the main site
• Step 4c: Reestablish the WiFi connection on the satellite at the detached site
Note: You must provide the Ethernet cables that are required for the setup.
Step 4a: Set up the WiFi connection on the master at the
main site
Perform this task on the AirBridge that must function as the master.
To set up the WiFi connection locally on the AirBridge that must function as the
master:
1. Connect an Ethernet cable to the LAN1 (PoE-24V) port on the AirBridge.
2. Connect the other end of the Ethernet cable to the PoE port on the power adapter.
Installation 36 Hardware Installation Guide