NETGEAR AirBridge WBC502 Hardware Installation Manual page 30

Insight Instant AirBridge WBC502 Hardware Installation Guide
The access point can be an AirBridge that functions as an access point, but can also be
any other model access point, including a third-party access point. The access point
broadcasts its WiFi signal to detached sites, each one with an AirBridge that functions
as a client bridge operation. At each detached site, a single pan-tilt-zoom (PTZ) camera
is connected to the AirBridge, so no switch is required at the detached site. You can
view the life stream and manage the camera from the main site.
To provide a WiFi connection to an outdoor device that is not WiFi-capable, complete
the following high-level steps:
1. Configure an AirBridge as a client bridge.
2. On the AirBridge, configure the same 5 GHz SSID and passphrase that is being
broadcast by the access point to which the AirBridge must connect.
3. Place the AirBridge at the detached site and attach a wired device such as a PTZ
camera by connecting it directly to the LAN port of the AirBridge power adapter.
The camera at the detached site functions on the same LAN as the devices at the
main site.
Applications 30 Hardware Installation Guide