Parameterization Of The Mcp - Siemens SINUMERIK 840Di sl Commissioning Manual

PROFIBUS DP Communication
8.7 DP slave MCP 483
8.7.2

Parameterization of the MCP

Interfaces
In the following figure, the interfaces are shown on the rear side of the module:
Figure 8-17 Position of interfaces on rear side of machine control panel
For a detailed description of the electrical and mechanical design and of the machine control
panel interfaces, please refer to:
References:
/BH/ Operator Components Manual, Chapter "MCP 483 Machine Control Panel"
Display of the software version
After the MCP has been electrically connected, all LEDs on the front side of the MCP flash
until communication is established between MCP and PLC.
Simultaneously pressing the two keys "Feed stop" and "Feed enable" (in the bottom right
corner) displays the version number of the current software version using the LEDs which
are now illuminated continuously.
Version No. = V
"Number of glowing LEDs in the left LED block".
"Number of glowing LEDs in the middle LED block".
"Number of glowing LEDs in the right LED block".
In the example (following figure), V 01.02.00 is displayed.
272
Commissioning Manual, 05/2008, 6FC5397–4CP10–4BA0
Manual