Setting The Boot Response For The Service Desktop; System Information After "Fatal Exception Error; Starting Oem Programs - Siemens SINUMERIK 840Di sl Commissioning Manual

Power-On and Power-Up
5.4 Service Desktop
5.4.3

Setting the boot response for the Service Desktop

The NC or MHI desktop settings are used to determine if the NC desktop (Windows desktop)
is displayed after booting the SINUMERIK 840Di sl, or if the HMI user interface, e.g. HMI
Advanced, is started immediately:
● NC Desktop
● HMI desktop
5.4.4

System information after "Fatal exception error"

After a "fatal exception error" (blue screen), system information is written to the following file:
● D:\Memory.dmp.
5.4.5

Starting OEM programs

OEM directories
OEM programs can be executed before starting the SINUMERIK system software. These
programs or their respective links must be stored in the following directories:
● C:\RunOEM\SeqOnce
● C:\RunOEM\Seq
Note
Sequential: The subsequent program will only be started when the previous program has
been ended.
● C:\RunOEM\ParOnce
● C:\RunOEM\Par
138
Autostart of the HMI application: OFF
Autostart of the HMI application: ON
Programs stored here are started once and sequentially.
Programs stored here are started on every power-up and sequentially.
Programs stored here are started once. They run in parallel with the HMI system software.
Programs stored here are initiated at every boot. They run in parallel with the HMI system
software.
Commissioning Manual, 05/2008, 6FC5397–4CP10–4BA0
Manual