Siemens SINUMERIK 840D sl Commissioning Manual page 20

Configuring the HMI system
2.3 Setting-up network connections
Figure 2-3
Operation:
The first entry in the line is the IP address.
The second entry is the computer name. The data already specified appears in the upper
section of the screen.
By selecting the "New" and "Edit" softkeys you can go to the lower half of the screen where
you can edit entries.
You can change back to the upper section by pressing the "Cancel" softkey (data is not
saved) or the "Save" softkey (data is saved).
With external drives (network connections) you need to specify the full network path
(\\computer name\release name\path data), whereby the path name is optional:
\\R4711\workpieces\template
\\R4812\\workpieces
These names must be available on the network computer. The network computer, for
example, is called "\\R4812". The share name WORKPIECES must be specified on any hard
disk drive on this computer.
20
Server name
Commissioning HMI-Embedded (IM2)
Commissioning Manual, 01/2008, 6FC5397-8CP10-1BA0