Connecting To A Computer - Konica Minolta Bizhub C650 Installation Manual

V. Connecting to a computer
There are two ways of connecting to a computer
from this machine.
With both connection methods, the network func-
tions of the copier can be used by connecting the
copier to the network.
Note:
Use a network cable (Category 5E or later recom-
mended) to connect to a computer.
a : Connecting the copier and image controller
with separate LAN cables
• With this connection method, the network func-
tions of the copier are not impaired, and the
image controller functions are added.
• The IP address settings for the copier and image
controller are specified separately.
• In order to use the network functions of the
copier, the network settings on the copier must be
specified according to the functions to be used.
1. Use a network cable to connect the LAN port of
the copier to the hub (LAN).
2. Use a network cable to connect port 1 of the
image controller to the hub (LAN).
b : Use the enclosed copier LAN cable (crossover
cable) to connect the copier, and connect the
image controller to a hub (LAN).
With this connection method, the following copier
function limitations are applied.
These functions can be used from the image con-
troller.
The function limitations are not applied to the image
controller.
1. Use the enclosed copier LAN cable (crossover
2. Use a network cable to connect port 1 of the
Port 1
Port 2
<Copier Network Settings>
Since the IP address of the copier can be set from
the image controller, it is not necessary to specify
the IP address from the copier. The IP address of
the copier appears at the end of the Configuration
Sheet for the image controller. However, the DHCP
settings must be specified from the copier in order
A00HIXE022HA
for the copier and image controller to communicate
internally through the crossover cable.
E-24
• AppleTalk and IPX/SPX protocols
• IPv6 and IPsec
cable) to connect the LAN port of the copier to
port 2 of the image controller.
image controller to the hub (LAN).
• Specifying the copier DHCP setting
Utility mode - "Administrator Settings" - "Network
Settings" - "TCP/IP Settings" - "IP Settings" -
"Auto Input" - "DHCP Settings" - "ON"
• In order to use the network functions of the
copier, the network settings on the copier must be
specified according to the functions to be used.
Port 1
Port 2
A00HIXE023HA