Unpacking The Machine - Konica Minolta Bizhub C650 Installation Manual

V. Unpacking the machine
1. Open the shipping box and take out the IU ship-
ping box and packaging material.
Note:
• Save the slope and cushion removed here for
later use.
• When storing or moving the IU, be sure to face
the TOP side up.
2. Separate the cushion into two and install them to
the pallet (at two places).
3. Take out the slope and protective tape and
remove nails from the plastic bag.
Cushion
IU
Slope
A00JIXC001DB
A00JIXC002DB
A00JIXC003DA
E-3
4. Position the slope as illustrated and drive nails in
to fix the slope in position.
5. Remove the mounting brackets (two each on the
right and left side) from the machine.
Note:
To remove the mounting brackets, use the allen
wrench on the machine side and a spanner on the
pallet side.
6. Holding onto the front cover and the back panel
of the machine, slide the machine down along the
slope.
Note:
Machine mass: 190 kg (418-3/4 lb)
• Perform this step on a level, stable site and
assign an adequate number of persons.
• When sliding the machine down, do not hold
onto the IR portion.
• Do not insert your leg under the slope.
A00JIXC004DB
A00JIXC005DB
A00JIXC006DC