Provisioning
Configuring the System
The Config menu (see
•
Standard options (see
•
ADC options (see
•
Date and time (see
•
Master clear (see
•
Reset to factory default configuration (see
Monitor
Performance
ID: xxxx--xxxx--xxxx--xxxx
Making Changes to Standard and ADC Options
Figure 7
and
Figure 8 on page 17
supported by HiGain HDSL2 units when connected to units from other vendors. ADC options are an extended set
of options that are only available when using HiGain units exclusively. For a description of each option and a list
of possible option settings, refer to
1
Press
C
to select the Config menu.
2
Use the
and
3
Use the arrow keys to select an option.
SPACEBAR
4
Press the
ENTER
5
Press
to activate your choice.
16
Figure 6
below) allows you to make the following changes:
"Making Changes to Standard and ADC Options" on page
"Making Changes to Standard and ADC Options" on page
"Setting Date and Time" on page
"Clearing the History, Alarm, and Event Log Screens" on page
"Resetting to Factory Defaults" on page
Event Log
Config
+-----------------------+
|
Standard Options
| ADC Options
| Test Mode
| Date and Time
| Master Clear
| Set Factory Defaults
+-----------------------+
08/01/2001 06:38:12
Figure 6. Config Menu
show the Standard and ADC configuration options. Standard options are those
Table 5 on page 18
arrow keys to select Standard Options or ADC Options, then press
to cycle through the available settings for that option.
January 9, 2002
14).
Inventory
Report
Rlogon
->
|
-> |
-> |
-> |
|
|
H2TU-C
and
Table 6 on page
19. To make changes to these options:
LTPH-UM-1049-02, Issue 2
16).
16).
33).
32).
Help
System: OK
ENTER
.
H2TU-C-319 List 4E