Download
Share
Print this page
ADC HiGain H2TU-C-319 List 1E Quick Installation
  1. Manuals
  2. Brands
  3. ADC Manuals
  4. Control Unit
  5. HiGain H2TU-C-319 List 4E
  6. Quick installation

ADC HiGain H2TU-C-319 List 1E Quick Installation

Hide thumbs Also See for HiGain H2TU-C-319 List 1E:
1
2
3
4
5
6
7

Advertisement

Quick Links

Download this manual
HiGain
HiGain
HiGain
HDSL2
L
1E
SETUP
M
O
D
E
STATUS
B
R
G
O
U
L
T
I
N
E
B
R
G
I
N
L
I
N
E
R
S
2
3
2
DCE
H
2
T
U
*
C
3
1
9
S
E
L
H2TU-C-319 L
L
Q
I
UICK
NSTALLATION
U
INE
NIT
1E
IST

Advertisement

loading

Related Manuals for ADC HiGain H2TU-C-319 List 1E

Summary of Contents for ADC HiGain H2TU-C-319 List 1E

  • Page 1 HiGain HiGain UICK NSTALLATION HiGain HDSL2 SETUP STATUS H2TU-C-319 L...

  • Page 2: Installation

    Select the Inventory menu, then type in the unit ID numbers. Change the settings of any system parameters, if necessary, by selecting the Config menu, Standard Options or ADC Options. (Configuration options can also be set from the front panel using the MODE and SEL buttons. See the “Front-Panel Configuration Options Using MODE and SEL”...

  • Page 3: Specifications

    H2TU-C-319 L The H2TU-C-319 List 1E (H2TU-C) line unit is the Central Office (CO) side of a T1 transmission system. When the H2TU-C is used in conjunction with a HiGain High-bit-rate Digital Subscriber Line 2 (HDSL2) remote unit (H2TU-R), the system provides 1.552 Mbps transmission on one unconditioned copper pair over the full Carrier Service Area (CSA) range.
  • Page 5 Once the H2TU-C is successfully installed and provisioned, access the Monitor or Performance menus to clear the Performance and Alarm History screens to ensure useful data. OOPBACK ESTING Initiate loopback testing from the HiGain HDSL2 Monitor screen or use the MODE and SEL pushbuttons.
  • Page 6 Front-Panel Diagnostic Messages Display Code Description (normal operating messages in bold) A=xx The loop attenuation of the longest (maximum loss) span, measured in dB. The multiplexers of the H2TU-C and H2TU-R are trying to establish synchronization. The multiplexers of the two devices on Span n are trying to establish synchronization with each other, where n is the number of the span.
  • Page 7 ©Copyright 2001 ADC DSL Systems, Inc. All rights reserved. Information contained in this document is company private to ADC DSL Systems, Inc., and shall not be modified, used, copied, reproduced or disclosed in whole or in part without the written consent of ADC.