Configuring The System; Config Menu - ADC HiGain H2TU-C-231 User Manual

LTPH-UM-1109-01, Issue 1

Configuring the System

The Config menu (Figure
•
Standard options
•
ADC options (Figure 8 on page
•
BERT Generator
•
Date and time (see
•
Master clear (see
•
Reset to factory default configuration (see
Monitor Performance
ID: xxxx--xxxx—-xxxx--xxxx
Making Changes to Standard and ADC Options
Figure 7 and Figure 8 on page 16
supported by HiGain HDSL2 units when connected to units from other vendors. ADC options are an extended set
of options that are only available when using HiGain HDSL2 units exclusively. For a description of each option
and a list of possible option settings, refer to
options:
1 Press C to select the Config menu.
2 Use the and
3 Use the arrow keys to select an option.
4 Press the SPACEBAR
5 Press ENTER to activate your choice.
H2TU-C-231 List 2
6) allows you to make the following types of system configuration changes:
(Figure 7 on page 16)
16)
(Figure 29 on page 52)
"Setting Date and Time" on page
"Clearing the History, Alarm, and Event Log Screens" on page
"Resetting to Factory Default Values" on page
Event Log Config
+----------------------+
| Standard Options ->
| ADC Options
| BERT Generator
| Date and Time
| Master Clear
| Set Factory Defaults |
+----------------------+
09/01/2001 12:30:01
Figure 6. Config Menu
show the Standard and ADC configuration options. Standard options are those
Table 5 on page 17
arrow keys to select Standard Options or ADC Options, then press
to cycle through the available settings for that option.
January 9, 2002
13)
Inventory Report Rlogon
|
-> |
-> |
-> |
|
H2TU-C
and Table 6 on page
Provisioning
23)
10)
Help
System: OK___
18. To make changes to these
ENTER .
15