Configuring The System; Configuration Menu - ADC HIGAIN HDSL2 Manual

Provisioning

Configuring the System

The Config menu (Figure
•
Standard options
•
ADC options (Figure 8 on page
•
Date and time (see
•
Master clear (see
•
Reset to factory default configuration
Monitor Performance
ID: xxxx--xxxx--xxxx--xxxx
Most of the H2TU-C-231 List 1F configuration options can also be set from a network test center
through TL1 commands embedded in the FDL ESF framed payload (non-intrusive) or in the
payload itself with 11-bit commands (intrusive).
To obtain additional information about remote provisioning commands, contact customer
service (see
Making Changes to Standard and ADC Options
Figure 7 and Figure 8 on page 15
that are supported by HiGain units when connected to units from other vendors. ADC options are an extended set
of options available only when using HiGain units exclusively. For a description of each option and a list of
possible option settings, refer to
1 Press C to select the Config menu.
2 Use the ↑ and ↓
3 Use the arrow keys to select an option.
4 Press the SPACEBAR
5 Press ENTER to activate your choice.
14
6) allows you to make the following types of system configuration changes:
(Figure 7 on page 15)
15)
"Setting Date and Time" on page
"Clearing the History, Alarm, and Event Log Screens" on page
(Figure 9 on page
Event Log Config
+----------------------+
| Standard Options ->
| ADC Options
| Date and Time
| Master Clear
| Set Factory Defaults |
+----------------------+
09/20/2000 01:36:13
Figure 6. Configuration Menu
"Appendix D - Product Support" on page
show the Standard and ADC configuration options. Standard options are those
Table 5 on page 16
arrow keys to select Standard Options or ADC Options, then press
to cycle through the available settings for that option.
October 2, 2000
12)
24)
Inventory Rlogon Help
|
-> |
-> |
|
H2TU-C
66).
and Table 6 on page 17. To make changes to these options:
152-231-116-01, Revision 01
25)
System: OK
ENTER .
H2TU-C-231 List 1F