Configuring The System - ADC HiGain H2TU-C-231 List 3F User Manual

Provisioning

Configuring the System

Monitor Performance
ID: xxxx--xxxx--xxxx—-xxxx
The Config menu (see
• Standard options (see
•
ADC options (see
•
Date and time (see
•
Master clear (see
•
Reset to factory default configuration (see
Most of the H2TU-C-231 List 3F configuration options can also be set from a network test center
through TL1 commands embedded in the FDL ESF framed payload (non-intrusive) or in the
payload itself with 11-bit commands (intrusive).
To obtain additional information about remote provisioning commands, contact customer
service. See
Making Changes to Standard and ADC Options
Figure 7 on page 15 and
are those supported by HiGain HDSL2 units when connected to units from other vendors. ADC options are an
extended set of options that are only available when using HiGain units exclusively. For a description of each
option and a list of option settings, refer to
To make changes to these options:
1 Press C to select the Config menu.
2 Use the ↑ and ↓
3 Use the arrow keys to select an option.
4 Press the SPACEBAR
5 Press ENTER to activate your choice.
14
Event Log Config
+-----------------------+
| Standard Options
| ADC Options
| Date and Time
| Master Clear
| Set Factory Defaults
+-----------------------+
04/10/2002 23:31:08
Figure 6. Config Menu
Figure 6) allows you to make the following changes:
Figure 7 on page 15).
Figure 8 on page 15).
"Setting Date and Time" on page
"Clearing the History, Alarm, and Event Log Screens" on page
"Resetting to Factory Defaults" on page
"Appendix D - Product Support" on page
Figure 8 on page 15 show the Standard and ADC configuration options. Standard options
Table 6 on page 17
arrow keys to select Standard Options or ADC Options, then press
to cycle through the settings for that option.
Inventory Report
->.|
-> |
-> |
H2TU-C
12).
68.
and Table 7 on page
June 12, 2002
LTPH-UM-1149-01
Rlogon Help
|
|
System: OKarm
25).
24).
20.
ENTER .
H2TU-C-231 List 3F