Using A Maintenance Terminal; Connecting To A Maintenance Terminal; The Logon Screen; Navigational Keys For The Higain Hdsl2 Maintenance Terminal Screens - ADC HiGain H2TU-C-319 List 4E User Manual

Provisioning
U M
SING A AINTENANCE

Connecting to a Maintenance Terminal

The craft port on the front panel allows you to connect the H2TU-C to a maintenance terminal (ASCII terminal
or PC running a terminal emulation program). Once connected to a maintenance terminal, you can access the
maintenance, provisioning, and performance screens.
To connect to a maintenance terminal:
1 Connect a standard 9-pin terminal cable to the RS-232 craft port, as shown in
front panel.
2 Connect the other end of the cable to the serial port on the maintenance terminal.
3 Start a terminal emulation program such as Procomm that emulates a VT100 terminal.
4 Configure the maintenance terminal to the following communication settings:
•
9600 baud
•
No parity
• 8 data bits
• 1 stop bit
• Hardware flow control to OFF
5 If necessary, press

The Logon Screen

The HiGain HDSL2 maintenance terminal screens allow you to monitor, provision, and troubleshoot an H2TU-C
system.
To select a menu from the HiGain HDSL2 logon screen, shown in
•
Press the underlined letter of the menu.
•
Use the arrow keys to select the menu and press
Table 3 summarizes the navigational keys. They are also listed in the onscreen Help menu.
describes the Logon screen menus.
Table 3. Navigational Keys for the HiGain HDSL2 Maintenance Terminal Screens
(a)
Key
SPACEBAR
ENTER
ESC
or CTRL + E
or CTRL + X
or CTRL + D
CTRL S
or +
CTRL R
+
(a) Legacy management units require the use of control keys instead of arrow keys.
12
T
ERMINAL
CTRL R
+ to refresh the HiGain HDSL2 logon screen.
Function
Cycle through selections.
Activate the current setting or choice, or display a menu.
Return to the parent menu.
Select the submenu or item above the current one, or return to the previous menu.
Select the submenu or item below the current one.
Select the menu or item to the right of the current one.
Select the menu or item to the left of the current one, or return to the previous menu.
Refresh the screen.
January 9, 2002
Figure 1 on page
Figure 3 on page 13, do one of the following:
ENTER .
LTPH-UM-1049-02, Issue 2
3, on the
Table 4 on page 13
H2TU-C-319 List 4E