Table of Contents
Advertisement
Foot-release tab
Toward center
Tab through hole in chassis
n
2. Remove the two chassis feet from the top of the system chassis by
pushing the foot-release tab inside the chassis in the direction
shown in Figure 4-14.
Chassis feet
Figure 4-14 Removing the Chassis Feet
The boards shown in the illustrations are not necessarily the configuration
needed for your system. Do not change your configuration to match the
configuration shown in the illustrations.
3. Attach the support bracket to the bottom of the chassis as follows:
a. Remove and save the two Phillips screws from the support
bracket (see Figure 4-15).
b. Align the holes of the support bracket on the inside of the
chassis with the holes of the chassis feet you removed in
step 2.
c.
Attach the support bracket to the bottom of the chassis using
the two Phillips screws removed in step 3a.
4-21
Installing the Fan Kit
Advertisement
Table of Contents
Troubleshooting
