Table of Contents
Advertisement
4-20
Preparing for Installation
Installing the Fan Kit
Captive screws
Support bracket
Installing Memory, the Avid Board Set, and the Fan Kit
To prepare the system for installation you must:
1. Shut down the system in the normal manner.
2. Unplug the system from the wall socket.
3. Turn off power to all attached peripherals.
4. Remove the panel from the left side of the system (see the system
user's guide provided by the maker of the system).
5. Lay the system down on the right side panel.
The fan kit ships fully assembled. However, it must be taken apart
before you can install it in the system. These instructions assume that
you have all the boards installed in the system.
To install the fan kit:
1. Remove the fan assembly from the support bracket by loosening
the two captive screws on the fan assembly (see Figure 4-13).
Figure 4-13 Fan Kit - Captive Screws
Fan assembly
Advertisement
Table of Contents
Troubleshooting
